Is
local control and indication important to you? If so,
this line of controllers and backup stations, available
in both 1/4 DIN panel mount and Field mount NEMA 4X versions,
may be the answer.
Rugged Construction
NEMA 4X 1/4 DIN panel and field mount versions
Thick
damage resistant keys
EMI/RFI
resistance
Input/output
isolation
Operator
Interface
3 line vacuum fluorescent display
English
prompts and messages
2
color backlit keys indicate controller state
Applications
Single and dual loop PID control for temperature or
process applications
Feedforwad/feedback,
Cascade, and Ratio control
Chlorination/dechlorination
control for water and waste water treatment
PID
backup and Auto/manual stations that are not a point
of failure
Convert, isolate, split, boost, and step down
process signals so field instruments can interface
directly with indicators, recorders, DCS, PLC, and
PC-based SCADA systems.
Take a weak, low-level RTD or thermocouple signal
and convert it to a high-level analog signal more
suitable for long-distance transmission through a
noisy plant, and ready for direct interface with an
indicator, recorder, PLC, DCS, or PC-based SCADA
system.
Provide on/off control, warn of trouble, or
provide emergency shutdown by sending one or more
alarm (relay) outputs when a monitored process
signal falls outside of a selected high and/or low
limit.
Break out analog and discrete process, status and
diagnostic signals from smart multivariable
transmitters and valves; monitor critical and
safety-related loops; prevent costly false
shutdowns; and warn of unwanted process or
instrument fault conditions.
Eliminate expensive point-to-point wires by
sending just a few—or thousands of—process
monitoring and control signals between the field and
control room on one digital communication link.
Convert a current signal to a pneumatic signal so
a DCS, PLC, or PC can control a valve or actuator;
or convert pneumatic signals to current signals so
remote pneumatic devices can interface with
electronic instruments and computer-based monitoring
systems.
Schedule maintenance, identify inefficiencies,
cut energy use, and prevent expensive damage to a
load device like a motor, pump, heater, or mixer by
accurately monitoring AC power use and trends.
Take a process input signal from a temperature,
pressure, level, or flow transmitter loop and view
real-time process status in rugged and hazardous
field environments.
Our versatile and economical instrument enclosure
systems are your solution for safely mounting
electronic instruments in the field. Featuring
standard dimensions and mounting configurations,
they are designed for use with our instruments, as
well as protection of other manufacturers'
equipment.
ALL REGISTERED TRADEMARKS ARE FULLY
ACKNOWLEDGED BY:
M&M Control Service, Inc. (ALL NAMES UNINTENTIONALLY EXCLUDED FROM
THIS LIST WILL BE INCLUDED IN THE NEXT REVISION UPON OUR
NOTIFICATION)
*This list may vary, as names not appearing on this list are
entitled to the acknowledgment of their Trademarks by M&M
Control Service, Inc.
(Powers™,
also known as, POWERS REGULATOR, MCC POWERS, POWERS-FIAT,
POWERS PROCESS CONTROLS, CRANE POWERS and POWERS, a Watts
Industries Company. The POWERS trademark is owned by
Powers, A Division of Watts Water Technologies, Inc.
M&M Control Service, Inc. Is a Stocking Distributor for
Powers™)
M&M CONTROL SERVICE,
INC. DOES NOT REPRESENT OR CLAIM ANY AFFILIATION WITH ANY
MANUFACTURER. WE FULLY ACKNOWLEDGE ALL TRADEMARKS AND/OR
NAMES WHICH ARE PICTURED AND/OR LISTED THROUGHOUT THE M&M
CONTROL SERVICE, INC. WEBSITE.
Now:
